Relearn Code: TOY-2

Relearn Procedures: Initialization following rotation and tire replacement.

1. Inflate all tires to pressure indicated on tire placard.
2. Turn ignition to ON position (engine off)
3. Hold down tire pressure reset button (located on instrument panel, knee bolster or inside glove box) until TPMS telltale flashed 3 times.
4. Initialization will be completed when ECU has received signals from all from all sensors. Process may take 2 - 3 minutes.
5. If initialization is not complete, drive vehicle for approximately 20 minutes.

* A properly formatted scan tool required to learn new sensor IDs when replacing sensors.

** Vehicle may be equipped with Main/2nd switch located at base of driver side knee bolster, underneath glove box, or inside glove box. Sensor IDs must be written to the position the switch is pressed.